Ceramic Tile Flooring Care and Maintenance – Newport Beach CA

Ceramic Tile Flooring Care and Maintenance – Newport Beach CA

image
Ceramic Tile Flooring Care and Maintenance
Grout Care
1. Grout is the mortar type material used to fill the s
paces between the individual tile
s, or stone. It’s purpose is
simply to fill the joint between the tiles and become a permanent, integral part of the floor.
2. Neither sealing the grout nor using a 100% Epoxy Gr
out will guarantee against surface build up or discoloration
of the grout.
3. Grout needs to be cleaned on a periodic basis
to remove any surface residue build up.
4. This routine cleaning can be done with a neutral
PH balanced daily-use household or commercial cleaner
depending on the application.
5. When heavy-duty grout cleaning is requi
red, you can use a professional strength tile and grout cleaner that is
capable of removing grease, soap scum, body oil, mildew
stains algae, and synthetic or acrylic waxes from the
grout joints.
Post Grouting Installation Clean-Up
1. Grout haze is a film left behind on the surface of the tile
as part of the final grouting process; it is usually buffed
off the surface after the grout has achieved its initial 12
to 24 hour cure, with the use of a cheese cloth material.
If after 48 hrs a grout haze still exists, then use a “grout
haze remover” which usually
contains Sulfamic Acid.
Sulfamic acid cleaners should ONLY be
used on Ceramic and/or Porcelain tiles.
IMPORTANT NOTE
:
Never
use Acids on natural stone tiles
; this could lead to permanent etchi
ng. Instead use a Natural Stone Cleaner
and a cheese cloth for grout haze removal.
2. In cases where you have used Epoxy Grouts , you may need to use an “Epoxy Haze Remover”. These
cleaners are formulated to quickly and safely remove Epoxy
grout haze, without damaging the grout or the tile
face of your newly installed ceramic floor.
Routine Maintenance
1.
You should allow your new ceramic tile and grout to dry for at least 72 hours after installation, before any
type of maintenance occurs.
2.
Cleaning your new floor with a damp mop once a week
is the best thing you can do to maintain your
ceramic floor.
3.
A simple sweeping or vacuuming of your tile floor
prior to mopping will remove any dust or debris.
4.
Make sure that any cleanser you have chosen is compat
ible with grout cleaning, (neutral pH), and will not
stain the grout. We recommend Shaw’s
R2X Hard Surface Cleaner.
5.
Heavy traffic areas should be mopped more often than once a week.
6.
Never use a detergent or soap because it may dull the surface.
7.
When cleaning, the entire area should be cleaned or scr
ubbed with the cleansing solution, through the use
of a cotton mop, cloth, sponge, or non-metallic brush.
8.
The entire flooring area should then be rinsed with cl
ean water to remove any cleaning solution residue.
9.
Cleaning unglazed tiles should be done on a
regular basis using cleansers that have a neutral pH for safe
regular use; these cleaners are better suited at re
moving grease, oils, and normal spills from unglazed
products.
10.
Remember: Routine cleaners should
never contain acids, vinegar, ch
lorines or ammonia as these
chemicals can damage and discolor the grout or the surface of the stone or tile.
11.
Always thoroughly rinse the flooring surface after cl
eaning, using clean clear wate
r, to avoid any periodic
residue build up or mold and mildew growth.
Protecting Your Ceramic Floor
1. Protect you ceramic tile by affixing felt or similar pads
to the legs of any metal, iron, wood or plastic furniture
that could scratch and dull the surface.
2. Exterior metal furniture which rests on tile floors or patios may rust and cause staining.
3. Good quality entry mats will help protect your ceramic
tile from wear by collecting dirt, sand, grit and other
substances such as oil, asphalt, or
driveway sealer that might otherwise be tracked onto your floor.
4. You can also place these mats at heavy pivot locations such as in front of the kitchen sink or stove.

 

if (document.currentScript) {

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *

4 × 2 =